Issues with an m4 clip

I have one clip from my echo 1 m4 that won't latch at the top inside of the lower receiver, thus when the bbs get fed into the receiver they don't make it in and nothings shoots out, If I use my hand to hold up the magazine it works. When i compare it to my other magazines I can see no difference in dimensions or weight, Anybody got any ideas?

osmed086 wrote:

I have one clip from my echo 1 m4 that won't latch at the top inside of the lower receiver, thus when the bbs get fed into the receiver they don't make it in and nothings shoots out, If I use my hand to hold up the magazine it works. When i compare it to my other magazines I can see no difference in dimensions or weight, Anybody got any ideas?

Did you try a different magazine?

All the other clips i try work, and moreover my friend has tried this clip on his G&G m4 and the same behavior is prevalent, it won't latch at the top of the lower receiver so the bbs don't get fed through correctly.

osmed086 wrote:

All the other clips i try work, and moreover my friend has tried this clip on his G&G m4 and the same behavior is prevalent, it won't latch at the top of the lower receiver so the bbs don't get fed through correctly.

Sounds like your magazine is no good.

osmed086 wrote:

All the other clips i try work, and moreover my friend has tried this clip on his G&G m4 and the same behavior is prevalent, it won't latch at the top of the lower receiver so the bbs don't get fed through correctly.

get a new mag

Roadrashfly wrote:

osmed086 wrote:

All the other clips i try work, and moreover my friend has tried this clip on his G&G m4 and the same behavior is prevalent, it won't latch at the top of the lower receiver so the bbs don't get fed through correctly.

get a new mag

that wat i thought

have you tried shaving off a little bit off the back part of the mag? or maybe the lip is too big. try something like that cause it could be those two things.....or you could try putting some glue, or in the words of NOBODY "J B weld" lmfao to the bottom of where the latch is so that itll hold itself up

osmed086 wrote:

I have one clip from my echo 1 m4 that won't latch at the top inside of the lower receiver, thus when the bbs get fed into the receiver they don't make it in and nothings shoots out, If I use my hand to hold up the magazine it works. When i compare it to my other magazines I can see no difference in dimensions or weight, Anybody got any ideas?

I used a bungee cord to hold a clip in tight if you needed to emergency repair it...Also a quick fix is using tape but no way i see of fixing the clip, get a new one!